Hello, friends,Today in this post we will learn how to hack Wifi password in 5 steps. We have been always seen many Wifi networks in our area. But most of them are password protected. So you cannot access the because you don’t have the password of that network. When you see the Wifi network you probably thought to get the password of that wifi network. But hacking a Wifi password is not an easy task because it requires a lot of coding skill. But don’t worry there is good news for you because, in this post, I am writing about how to hack Wifi password without knowing any coding skills. Just follows the simple steps describe in the post and hack the wifi password.
Requirement for crack password:-
- Wireless card that supports promiscuous mode.
- An active access point with WPA2 security and WPS enabled.
Steps to hack Wifi password :-
Step 1:–First of all, open your terminal by pressing CTRL+ALT+T using keyboard and type airmon-ng.1
Step2:-In step second, you need to stop your wireless monitor mode by running airmon-ng stop wlan0.
Step3:-In the third step, you are ready to capture the wireless traffic nearby you. For capturing wireless traffic, you have to run air dump-ng wlan0 and your wireless interface start capturing data.
Step4:-In previous step 3, you find the access point with encryption algorithm WPA2 and note the access point channel number. Now you have to find which of them is a WPS-enabled access point. Typewash -i wlan0 -c 8 -C -s. If WPS locked status is no, then you are ready to crack WiFi and move to the final step.
Step5:-In this final step, you will use reaver to crack WPA2 password. reaver -i-b’fail-wait=360
Now Wi-Fi password is cracked. But note that sometimes it will take few minutes to crack a password.